How to Install a Toilet

In some cases, we need to replace our toilet, and this can mean savings on water bills, especially if you have a non-stop toilet. However, in some cases, you may just want to get a new one to refresh the look of your bathroom. Either way, you’ll be excited that it doesn’t take all day to install the toilet, especially if you are just replacing an old toilet with a new one.Are you wondering on How to replace a toilet? Replacing the toilet is not as difficult as some people think. All you need is a little knowledge that you will get in this article. If you follow these steps, it will take less than an hour to replace the toilet.


Get the tools you need!

You only need a few tools to replace the toilet. You will need an adjustable wrench or a standard set of wrenches of different sizes. You will also need a razor and cleaning towels.

The first step to replacing a toilet is to clean the area and make sure that exposure to pests is minimal. Once the toilet in your bathroom is clean enough, it is important to stop the water supply that reaches the toilet. You must make sure that all the water is removed from the toilet. If you find that there is a very small end at the end of the process, just get a vacuum cleaner that is able to absorb water and remove what is left in the toilet. For your safety, it is important to make sure that you clean any water that falls on the floor.

Once the dirt is clean, cut the water supply to the toilet. Next, you should cut the screws on the floor on both sides of the toilet. Once the screws are removed from the floor, you will be able to remove the toilet from the floor. Unfortunately, you may find that water comes out of the toilet despite your best efforts to finish the toilet water. Be sure to protect yourself and clean this water. Once you look around the toilet, you will find two pieces of wax like a ring. Make sure these seals are completely removed and replaced.
Now, you are ready to install a new toilet. It would only go to the site where the old toilet was. Make sure that when you cut a new toilet downstairs you use fresh pasta and when you are in the ground you do not remove the shovel. If you do, you will find that the toilet is leaking. Once the toilet is in place and the screw is installed, you must tighten the line that sends water from the shut-off valve to the toilet. If this line is distorted or appears to be damaged, it is important to replace this part as well. Once everything is in order and all the pieces are sorted, you can turn on the water supply and allow the tank to be filled. Once you have done that, rinse. If you do not see any visible leaks, then you have properly installed a new toilet in your bathroom.

Click here to visit our valued sponsor! Or, check out the step by step video below!